Avaya Octel 200 Installation And Maintenance Manual page 635

7. Enter the password. Press
.
Enter
8. Install the disk.
9. @DSKTST
Enter
10. @DSKMAP
Enter
@DSKMAP
SLOT
+−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−+
SHELF B|
|
+−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−+
SLOT:
+−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−+
SHELF C| Voice 1
| ID: V1 ACTIVE |
+−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−+
Choose the Correct Disk Option
11. @DISKO
Enter
PB60019−01
To log on to system.
Refer to the Hardware Replacement chapter, Hard Disk Drive (HD)
Replacement section, for procedures to follow for physical installation of a
drive. Hard disks may be hot plugged.
At the @ prompt enter the slot number for the added drive. The software
tests the slot and updates its status record.
If status on the new drive shows active, repeat steps 8 and 9 until status
reports "unknown." This may take several attempts.
Repeat DSKTST for each drive to be added.
Reviews the status of all drive slots.
1 2
| System 1
| ID:S1 ACTIVE
1 2
| Voice 2
ID: EMPTY
The following menu is presented:
@DISKO
CURRENT STATUS
Slot Type ID
−−−−−−−−−−−−−−−−−−−−−−−−−−−−
B3
B4
C1
DISK OPTIONS
1. ADD DISK
2. REMOVE DISK
3. REPLACE A DISK
4. RESTORE SYSTEM
5. UPGRADE LANGUAGES
6. UPGRADE SYSTEM
Select option to be performed
(1−5 − Empty line = EXIT)
:1
Drive in slot C1 has been removed.
3
| System 2 |
| ID:−− EMPTY | ID:−− EMPTY
3
| Voice 3 |
| ID: EMPTY | ID: EMPTy
Status Configured
System1 S1 ACTIVE
System2 S2 ACTIVE
Voice1 V1 ACTIVE
Procedures
4
Voice 1 |
|
4
Voice 4 |
|
Configured
Configured
Configured
Octel 200/300
12-47
S.4.1