Listing And Clearing Reports; Listing A Report - Avaya Octel 200 Installation And Maintenance Manual

5-2 Installation and Maintenance Volume
5.2

LISTING AND CLEARING REPORTS

Information is collected and stored in various internal tables. The information accumulates until the
report is cleared. Reports can be listed without affecting the accumulated data. Once the command to
clear a report is entered, the values are reset to zero and resume accumulating.
Most reports show only the date they are run. At the top of reports 1, 2, 6 and 10 are two dates. The
"from" date and time indicate when the table was last cleared. The "to" date and time indicate when the
report was last printed. It is recommended that reports be listed and cleared on a regular basis. The
reports can display individual values up to 65535.
.
Beginning with Serenade Release 3.0, the following reports can display individual values up to
999,999.
System Performance
Digital Network Performance
Network Traffic
Digital Network Activity
Disk Usage
Port Statistics
Integration Calling Statistics
System Performance by COS
For a report showing the attributes associated with the COS Table, CSTAT Table, SCHEDULE Table, and
all INFORMATION Tables defined in the SCHEDULE Table, refer to the Configuration volume, COS
chapter, How to Configure the COS Table section, for the LIST PROFILE command.
.
This chapter describes all reports except the DID/E&M Trunk Interface report, which is detailed in
DID/E&M Trunk Interface Installation and Maintenance Manual. For information about Direct
Access Cards, refer to the Direct Access Card (DAC) Installation and Maintenance Manual.

Listing a Report

Reports are printed by selecting from the LIST REPORT menu. At the @ prompt enter
LIST REPORT or L R
@L R
1. SYSTEM PERFORMANCE.
2. NETWORK TRAFFIC.
3. USER MESSAGE STATISTICS.
4. USER CALLING STATISTICS.
5. DISK USAGE.
6. PORT STATISTICS.
7. MAILBOX USAGE.
8. USER STATUS DETAIL.
9. INTEGRATION CALLING STATISTICS.
10. SYSTEM PERFORMANCE BY COS.
SELECT REPORT TO BE LISTED. (1 − 10, EMPTY LINE = EXIT)
:
Select the number of the report you wish to list.
.
Enter L R # (report number), to designate a specific report before the menu is displayed.
Octel 200/300 S.4.1 PB60019−01