Table of Contents
Advertisement
8-34
Installation and Maintenance Volume
Table 8-2 Hardware Error Types and Remedies (continued)
Error Type:Name
64. LAN Hardware
Error (continued)
C = DATA PACKET RECEIVED GOT CHECKSUM ERROR
65 DMA Channel
Error
66. LAN Reported
Hardware Error
DATA-1 =
ERROR CODE ON LAN:
Octel 200/300
S.4.1
Source
Problem detected by
the LAN.
Data communication is being corrupted between the local system and
the remote system at the location specified.
values as follows:
DATA-2
1
On open conn request received
2
On connless data packet
3
On data packet received
4
On connection grant received
5
On connection reject received
6
On a query packet received
7
Remote end had the cksum error
DATA-3 =
LOW BYTE OF LOCATION
DATA-4 =
UPPER BYTE OF LOCATION
The LAN guarantees that if a packet gets through, it
REMEDY:
should be perfect, regardless of line conditions.
Therefore, this most likely points to a software problem.
Was the software recently changed or upgraded at either
location? If this continues, contact your technical support
center.
To determine the other location: Subtract 2 from the
number in Data-2 and Data-3 to get the location number
starting from 1. In
determine the name of the corresponding location.
Problem with CPU
card
Problem detected by
the LAN.
01 = ERROR LOGGED PRIOR TO SYNC-UP WITH CPU SOFTWARE
Contact your technical support center.
REMEDY:
Remedy
Dependent on the DATA-1 values described
below.
, list the
UPDATE
LOCATION T
Replace CPU card
Dependent on the DATA-1 values as
described below.
Priority
3
able to
2
3
PB60019−01
Advertisement
Chapters
Table of Contents
