Match Source-Address Mac; Match Srcl4Port - NETGEAR ProSafe GSM7228PS Cli Manual

match source-address mac

This command adds to the specified class definition a match condition based on the source MAC
address of a packet. The <address> parameter is any layer 2 MAC address formatted as six,
two-digit hexadecimal numbers separated by colons (e.g., 00:11:22:dd:ee:ff). The <macmask>
parameter is a layer 2 MAC address bit mask, which may not be contiguous, and is formatted as
six, two-digit hexadecimal numbers separated by colons (e.g., ff:07:23:ff:fe:dc).
Default none
Format
match source-address mac <address> <macmask>
Mode Class-Map Config
Ipv6-Class-Map Config
match srcip
This command adds to the specified class definition a match condition based on the source IP
address of a packet. The <ipaddr> parameter specifies an IP address. The <ipmask>
parameter specifies an IP address bit mask and must consist of a contiguous set of leading 1 bits.
Default none
Format
match srcip <ipaddr> <ipmask>
Mode Class-Map Config
match srcip6
This command adds to the specified class definition a match condition based on the source IP
address of a packet.
Default none
Format
match srcip6 <source-ipv6-prefix/prefix-length>
Mode Ipv6-Class-Map Config

match srcl4port

This command adds to the specified class definition a match condition based on the source layer 4
port of a packet using a single keyword or numeric notation. To specify the match condition as a
single keyword notation, the value for <portkey> is one of the supported port name keywords
Quality of Service (QoS) Commands
ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
v1.0, May 2010
6-18