Requirements For Using Ssh; Configuring Ssh; Figure 98 Ssh; Table 71 Ssh - ZyXEL Communications ZyWall P1 User Manual

ZyWALL P1 User's Guide

13.7.1 Requirements for Using SSH

You must install an SSH client program on a client computer (Windows or Linux operating
system) that is used to connect to the ZyWALL over SSH.

13.8 Configuring SSH

To change your ZyWALL's Secure Shell settings, click REMOTE MGMT, then the SSH
tab. The screen appears as shown.

Figure 98 SSH

The following table describes the labels in this screen.

Table 71 SSH

LABEL
Server Host Key
Server Port
Server Access
Secure Client IP
Address
Apply
Reset
Note: It is recommended that you disable Telnet and FTP when you configure SSH
for secure connections.
202
DESCRIPTION
Select the certificate whose corresponding private key is to be used to identify the
ZyWALL for SSH connections. You must have certificates already configured in the
My Certificates screen (click My Certificates and refer to
for details).
You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Select the interface(s) through which a computer may access the ZyWALL using
this service.
A secure client is a "trusted" computer that is allowed to communicate with the
ZyWALL using this service.
Select All to allow any computer to access the ZyWALL using this service.
Choose Selected to just allow the computer with the IP address that you specify to
access the ZyWALL using this service.
Click Apply to save your customized settings and exit this screen.
Click Reset to begin configuring this screen afresh.
Chapter 10 on page 151
Chapter 13 Remote Management