Local Mode; Voip Trunk Configuration - Nortel BCM50 Documentation Update

Page 17, To increase the number of survivable IP users
The following information is removed from this section:
"Upon SRG activation, the maximum number of 80 IP users is available. Therefore, there is no need to increase
that number."
Page 23, Local mode
The following note is added to this section:
Note:
Page 29, VoIP trunk configuration
The following step is inserted before the previous step 1:
1 Configure routing table:
Configuration > Resources > Telephony Resources > Modules panel > IP Trunks row > Routing Table.
External Reference: Networking Configuration Guide (NN40020-603).
Page 30, VoIP trunk configuration
The following step is added after step 3, and step 3 is modified:
3 Configure H323 settings:
Configuration > Resources > Telephony Resources > Modules panel > IP Trunks row > H323 Settings
tab
Internal Reference: Gatekeeper routing on page 73.
External Reference: Networking Configuration Guide (NN40020-603).
4 Configure SIP settings:
Configuration > Resources > Telephony Resources > Modules panel > IP Trunks row > SIP Settings
tab
Internal Reference: Gatekeeper routing on page 73.
External Reference: Networking Configuration Guide (NN40020-603).
Page 38, Virtual trunk capacity
The following sentence is added to this section:
"SRG50 supports 24 virtual IP trunks that are either H.323 only, SIP only, or a combination of the H.323 and SIP."
BCM50 3.0 Documentation Update
The IP Phone KEM is supported on an SRG with normal mode
IP Phones. It does not function with local mode or test local mode
IP Phones.
17
NN40020-400