Omron CRT1 - 10-2008 Operation Manual page 95

Connecting Cables and Terminating Resistor
Round Cable II
Connection Method
Flat Cable I
Installation Method
72
Round cable I
Note Before connecting the cable wires to the Terminating Resistor, first attach the
M3 crimp terminals shown below to the wires.
6.0 mm max.
Attach a DCN4-TM4 Terminating Resistor to the DCN4-TR4 Flat Connector
Socket connected to the cable.
Round cable II
Flat Connector Socket
Push in the Terminating Resistor until it clicks into place.
Note To remove a Terminating Resistor once it has been connected, press in on the
latches on both sides and pull it out.
Attach a DCN5-TM4 Terminating Resistor to the DCN5-TR4 Flat Connector
Socket connected to Communications Cable.
Flat Connector Socket
Push in the Terminating Resistor until it clicks into place.
Note To remove a Terminating Resistor once it has been connected,
press in on the latches on both sides and pull it out.
BDH (black) or BDL (white)
BDL (white) or BDH (black)
6.0 mm max.
Terminating Resistor
Terminating
Resistor
Section 3-4
Terminating Resistor