Omron CRT1 - 10-2008 Operation Manual page 244

Units with Connectors
Output Section Specifications
Item
Model
I/O capacity
Internal I/O common
Rated output current
Residual voltage
Leakage current
ON delay
OFF delay
Load short-circuit detection
Disconnection detection
Number of circuits per common
Isolation method
Output indicators
Power supply type
Current supplied to output
devices
I/O power supply current con-
sumption
Output handling for communica-
tions errors
Component Names and Functions (Same for CRT1-MD32S(-1)/CRT1-MD32SH(-1))
Indicator Section
Communications
Indicators
I/O Indicators
CRT1-MD32S
16 outputs
NPN
0.5 A/output, 4 A/common
1.2 V max. (0.5 A
DC, between
each output ter-
minal and the G
terminal)
0.1 mA max.
0.5 ms max.
1.5 ms max.
---
---
16 outputs/common
Photocoupler
LED (yellow)
Multi-power supply
100 mA/output
20 mA max. for 24-VDC power supply
voltage
Select either hold or clear from CX-Integrator.
Node address switches: ×10 and ×1 (from left)
Communications
indicators:
MS and NS
Communications
connector
Refer to 4-1-3 Communications Indicators.
The meanings of the I/O indicators are given in the following table.
Specification
CRT1-MD32S-1 CRT1-MD32SH
PNP NPN
1.2 V max. (0.5 A 1.2 V max. (0.5 A
DC, between DC, between
each output ter- each output ter-
minal and the V minal and the G
terminal) terminal)
Supported.
Operates at 3 mA/point max. (Does
not operate at over 3 mA.)
15 mA max. for
24-VDC power
supply voltage
Input indicators 0 to 15
e-CON connectors
Output I/O power supply connector
Section 5-4
CRT1-MD32SH-1
PNP
1.2 V max. (0.5 A
DC, between
each output ter-
minal and the V
terminal)
60 mA max. for
24-VDC power
supply voltage
Output indicators 0 to 15
221