Omron CRT1 - 10-2008 Operation Manual page 442

Word Slave Unit and Bit Slave Unit Functions
Settings Using the CX-Integrator
1,2,3...
rect monitoring operations will begin again from the point of the next start
trigger.
(3) If the measurement start trigger is input and the monitoring set value ex-
pires, the flag in the internal Unit Status Area turns ON even if the mea-
surement end trigger has not been input. The Unit's operation time
monitor value will retain the previous measurement value until the mea-
surement end trigger is input.
1. Turn ON the power supply to the CompoNet Slave Unit.
2. Double-click the icon of the Slave Unit to set in the Network Configuration
Window to open the Configuration Window. (Alternatively, right-click the
icon and select Parameters - Edit from the pop-up menu.)
3. Click the Operation Time Tab.
4. Double-click the Equipment Name to be monitored. The Edit Terminal Win-
dow will be displayed. Enter the set value in the Operation Time Field and
select the points to be monitored from the pull-down lists of the Start Point
and End Point Fields. Then select the ON edge or OFF edge monitoring in
the Edge Pattern Field and click the OK Button.
5. Return to the General Tab Page, click the Transfer [PC to Unit] Button to
download the data, and then click the Reset Button to reset the Unit.
6. Click the OK Button and exit the window.
Section 11-3
419