Omron CRT1 - 10-2008 Operation Manual page 81

Preparing Flat Connectors
Preparing DCN4-BR4 Flat Connector Plugs
Component Names
1,2,3...
58
Be sure there are no gaps here.
Cable labels
(Flat cable: black, blue, white, and red)
Black
Lock lever
■ Cutting the Cable
Cut the cable perpendicular to the length.
To prevent short-circuits, cut the cable with a sharp blade, such as wire cut-
ters, and be sure that there are no whiskers on the wires.
■ Attaching the Cable
Align the cable labels and cable colors and insert the cable.
Confirm that the cable is inserted all the way to the back. (The cover is semi-
transparent.)
■ Pressure-welding the Connector
The connector is pressure-welded by using the DWT-A01 Pliers.
1. As shown below, align the center (see arrows) of the connector cover with
the center of the pressure-welding block on the DWT-A01 Pliers.
Be sure the connector is locked on both
the left and right sides.
Insert the cable to this point.
Section 3-3