Omron CRT1 - 10-2008 Operation Manual page 90

Connecting Cables and Terminating Resistor
Using Flat Cable I
Using Flat Cable II
6.0 mm max.
Attach a DCN4-BR4 Flat Connector Plug to the DCN4-TR4 Flat Connector
Socket connected to Communications Cable.
Flat Connector Plug
Flat Connector Socket
■
Installation Method
Be sure the surface of the Flat Connector Plug on which line colors are indi-
cated (red, white, black, and blue) is facing downward and press in the Con-
nector until it clicks into place.
Note To remove a Connector once it has been attached, press in on the
latches on both sides of the Connector and pull it out.
Attach a DCN5-BR4 Flat Connector Plug to the DCN5-TR4 Flat Connector
Socket connected to Communications Cable.
Flat Connector Plug
Flat Connector Socket
■
Installation Method
Place the Flat Connector Plug so that the white line on the cable is facing
downward and press in the Connector until it clicks into place.
Note To remove a Connector once it has been attached, press in firmly
on the latches on both sides of the front of the Connector and pull
it out.
6.0 mm max.
Slave Unit
Slave Unit
Section 3-4
67