Omron CRT1 - 10-2008 Operation Manual page 86

Preparing Flat Connectors
1,2,3...
2. Hold the cable so that it does not move and close the cover.
■ Pressure-welding the Connector
Use the DWT-A02 Pliers to pressure-weld the connector.
1. As shown below, align the center (see arrows) of the connector cover with
the center of the pressure-welding block on the Pliers.
Pliers
2. Squeeze firmly on the Pliers until the lock on the connector clicks into
place.
3. After attaching the cable, confirm that it is properly pressure-welded as
shown below.
Be sure there are no gaps here.
Connector position reference surfaces
Connector cover
Be sure that the connector is locked.
Section 3-3
63