Omron CRT1 - 10-2008 Operation Manual page 71

Installing Slave Units
Mounting Procedure
Mounting Dimensions
Vertical Mounting to a Wall
48
Example: Mounting a CRT1-V@D32ML Slave Unit with MIL Connectors
1. Attach the Mounting Bracket to the panel surface (or wall) with two Phillips
screws, as shown in the following diagram. For mounting hole dimensions,
refer to Dimensions above.
2. Mount the Slave Unit to the Mounting Bracket. The Mounting Bracket is the
same shape as a DIN Track, so use the same method as when mounting
to a DIN Track.
• Units with e-CON Connectors (CRT1-V@D08S(-1)) or MIL Connectors
(CRT1-V@D16ML(-1))
(The Unit shown in the diagram is the CRT1-V@D08S(-1).)
Panel surface (wall)
Horizontal (side)
mounting to panel
surface (or wall)
Mounting Bracket
(mm)
6.0
Section 3-1
SRT2-ATT02
Mounting Bracket