Table of Contents
Advertisement
Temperature Input Units
Note
Setting Using the CX-
Integrator
1,2,3...
338
SW1
SW2
OFF
ON
ON
ON
OFF
OFF
ON
OFF
OFF
ON
ON
ON
Note If the settings are incorrect, the MS Indicator will flash red and the
Unit will not operate. In this case, make the settings again and reset
the power supply.
CRT1-TS04P
SW1
SW2
Always
OFF
OFF
ON
Note If the settings are incorrect, the MS Indicator will flash red and the
Unit will not operate. In this case, make the settings again and reset
the power supply.
1. Always set pin 5 and pin 7 to OFF (default).
2. Always set pin 8 to ON if the DIP switch is used to set the ranges. If this pin
is OFF, the DIP switch settings will not be enabled.
3.
The DIP switch settings are read when the power is turned ON.
4. ° C/ ° F display settings cannot be set individually for each input.
Input types can be set for each temperature input using the CX-Integrator.
Use the following procedure.
1. Turn ON the power supply to the Temperature Input Unit.
2. Double-click the icon of the Temperature Input Unit to be set in the Network
Configuration Window or right-click the icon and select Parameter - Edit.
The Configuration Window will be displayed.
3. Click the tab for the input where the input type is to be set and select an
input type in the Input Type Field.
SW3
SW4
OFF
ON
OFF
ON
ON
ON
ON
ON
ON
ON
ON
ON
SW3
SW4
Always OFF.
Section 7-5
Input type
U
N
W
B
PL2
Not used.
Input type
PT100 (−200 to 850°C)
PT100 (−200 to 200°C)
Advertisement
Chapters
Table of Contents
Troubleshooting
