Omron CRT1 - 10-2008 Operation Manual page 348

Overview of Temperature Input Units
1,2,3...
I/O Data
Temperature Data 1
■
Allocating Selected I/O Data Patterns
Data such as Status Flags can be allocated together with Temperature Data 1
as I/O in the following combinations. The data to be combined can be selected
from the CX-Integrator.
Example: Allocating Temperature Data 1 + Top/Valley Detection Timing Flags
in the Master Unit using normal display.
15
Top Detection Timing Flag
■
Using the CX-Integrator
1. Turn ON the power supply to the Temperature Input Unit.
2. Double-click the icon of the Temperature Input Unit to be set in the Network
Configuration Window or right-click the icon and select Parameter - Edit.
The Configuration Window will be displayed.
3. Click the General Tab and select an I/O data pattern in the Default Con-
nection Path (In) Field. The following example shows selecting the temper-
ature data and status flags.
4. Click the Transfer [PC to Unit] Button to download the data and then click
the Reset Button to reset the Unit.
5. Click the OK Button and exit the window.
Temperature Data 1 is used to monitor the temperature input value. The tem-
perature input value is allocated as the default setting, but any of the following
data can be allocated: temperature input value, peak value, bottom value, top
value, valley value, or rate of change.
Note The comparator function can be used for the data allocated as Temperature
Data 1.
8 7
Temperature Data 1 for Input 0
Temperature Data 1 for Input 1
Temperature Data 1 for Input 2
Temperature Data 1 for Input 3
Valley Detection Timing Flag
Section 7-2
0
325