Preparing Flat Connectors
1,2,3...
Line Extensions and Terminating Resistor Connections
2. Hold the cable so that it does not move and close the cover.
Note When extending the cable or connecting it to a Terminating Resis-
tor, make sure that the end of the cable is inserted all the way to the
cable stopper so that it will not be pulled out.
■ Pressure-welding the Connector
Use the DWT-A02 Pliers to pressure-weld the connector.
1. Set the connector on the pressure-welding block of the crimping tool.
As shown below, align the center (see arrows) of the connector cover with
the center of the pressure-welding block on the Pliers.
Pliers
2. Squeeze firmly on the Pliers until the lock on the connector clicks into
place.
Connector position reference surfaces
Connector cover
Section 3-3
61