Omron CRT1 - 10-2008 Operation Manual page 328

Analog Input Slave Units
Specifying the Analog
Data
Setting Using the CX-
Integrator
1,2,3...
3. Click the General Tab and select the desired I/O data (pattern) from the
pull-down menu under the Default Connection Path (In) Field.
4. Click the Transfer [PC to Unit] Button to download the data, and then click
the Reset Button to reset the Unit.
5. Click the OK Button and exit the window.
One of the following six processed values can be selected as the analog data:
Analog Input Value (raw value), Peak, Bottom, Top, Valley, and Rate of
Change. These values can be selected alone or in combination with the Sta-
tus Flags.
1. Turn ON the power to the CompoNet Slave Unit.
2. Double-click the icon of the Slave Unit to set in the Network Configuration
Window to open the Configuration Window. (Alternatively, right-click the
icon and select Parameters - Edit from the pop-up menu.)
3. Open the tab page for the analog data to set, and select the data to be as-
signed from the drop-down list for the Analog Data.
Section 6-4
305