Omron CRT1 - 10-2008 Operation Manual page 80

Preparing Flat Connectors
1,2,3...
Note
■ Attaching the Housing
Confirm that the cable labels and cable colors match and then temporarily
secure the housing to the cover.
Housing
Note The housing cannot be removed from the cover once it has been
attached. The connector may be damaged if the housing is force-
fully removed.
■ Pressure-welding the Connector
The connector is pressure-welded using the DWT-A01 Pliers.
1. As shown below, align the center (see arrows) of the connector cover with
the center of the pressure-welding block on the Pliers.
Pliers
2. Squeeze firmly on the Pliers until the lock on the connector clicks into
place.
(1) Do not pressure-weld the connector cover at the edges.
(2) Do not pressure-weld the connector cover at the back of the pressure-
welding block.
(3) Set the connector in the correct orientation.
OK
NG
3. After attaching the cable, confirm that it is properly pressure-welded as
shown below.
Connector cover
NG
Section 3-3
57