Omron CRT1 - 10-2008 Operation Manual page 334

Analog Output Slave Units
Indicator Section
Communications
Indicators
Switch Settings
Setting the Node Address
Setting the Output Ranges
Note
Refer to 4-1-3 Communications Indicators.
The node address is set as a decimal number with the 10s digit set on the left
rotary switch and the 1s digit set on the right rotary switch. (The maximum
node address is 63.)
The setting on the rotary switches is read when power is turned ON.
0
0
1s digit of node address
10s digit of node address
1 2 3 4 5 6 7
Each pin is set according to the following table.
Pin No. Setting
1 Sets output range for Out-
put 0
2
3
4 Sets output range for Out-
put 1
5
6
7 Always OFF.
8 Range setting method
(1) Always use the default setting (OFF) for pin 7.
(2) Always set pin 8 to ON if the DIP switch is used to set the range. If this
pin is OFF, the DIP switch settings will not be enabled.
(3) The DIP switch settings are read when the power is turned ON.
8
ON
Specification
Default setting: All pins OFF
Default setting: All pins OFF
Always set this pin to OFF. Unexpected oper-
ation may result if it is turned ON.
OFF: Use CompoNet Support Software.
ON: Use DIP switch.
Section 6-5
311