Installing Slave Units
Vertical Mounting
Mounting Procedure
Horizontal Mounting
CRT1-ATT02
13
SRT2-ATT02
7.3
Use a Mounting Bracket to vertically mount a Slave Unit to a panel or a wall.
Example: Mounting a CRT1-V@D32ML Slave Unit with MIL Connectors
Vertical on
panel surface
(wall)
1. Attach the Mounting Bracket to the panel surface (or wall) with two Phillips
screws, as shown in the following diagram. For mounting hole dimensions,
refer to Dimensions above.
2. Mount the Slave Unit to the Mounting Bracket. The Mounting Bracket is the
same shape as a DIN Track, so use the same method as when mounting
to a DIN Track.
Use a Mounting Bracket to horizontally mount (side mount) a Slave Unit to a
panel or a wall.
Mounting Hole Dimensions
26.7
Two, 3.2 dia. or M3
Mounting Hole Dimensions
32.5
Two, 3.2 dia. or M3
Panel surface (wall)
SRT2-ATT02
Mounting Bracket
Section 3-1
(mm)
(mm)
47