Configuration With The Osd; Lens; Exposure - EverFocus HDCCTV EZH5242 User Manual

1080p hdcctv ip66 ir bullet camera

Hide thumbs Also See for HDCCTV EZH5242:

Table of Contents

5. CONFIGURATION WITH THE OSD

Once you have opened the OSD's main menu on

your screen, use the UP and DOWN buttons to

scroll to the menu item of your choice. Use the

LEFT and RIGHT buttons to toggle between the

different modes (right-hand column) of the

menu item.

It is the DC mode as a factory default.

Once you have opened the OSD's main menu on your screen, use the UP and DOWN buttons to

scroll to the "EXPOSURE" menu item. Press the ENTER button to open the Exposure submenu.

Main menu

SHUTTER

Use the LEFT and RIGHT buttons to adjust the shutter speed. Choose from 1/30 ~ 1/50000, x2 ~

x60, FLK, and AUTO. Any selection other than AUTO and 1/30 will disable the SENS-UP field two

lines below this field.

AGC

This stands for Auto Gain Control (basic low-light signal amplification). Choose from LOW ~

HIGH. The higher the AGC, the brighter the screen, but the level of noise will also increase.

SENS-UP

SENSE UP is used to maintain a vivid screen image by automatically boosting low light levels.

Use the LEFT and RIGHT buttons to switch this function on/off and adjust its settings.

Choose from OFF or AUTO. AUTO has a submenu option where you can set the SENS-UP level

(x2 ~ x60). (No more than 8X SENS-UP is recommended without careful consideration of

application conditions.)

Submenu

Table of Contents