Settings For Each Function; Using A Material Effectively And Cutting Along The Vertical Dimension (Rotate Function) - Rotate Key And Rotate Led - Roland CAMM-1 User Manual

4 Settings For Each Function

4-1 Using a material effectively and cutting along the
vertical dimension (Rotate function) -- ROTATE Key
and ROTATE LED
This function sets the origin point at the bottom right and rotates the text or graphics 90° (see pictures below). This function is
used when the intended design will not fit in the width (horizontal dimension) of the material, such as long strings of text. If there
is still unused material on the right side, rotation allows you to use this remaining material effectively.
When the character string "Roland" is rotated by 90°, the X axis, Y axis, and origin change as follows:
0° Rotation - Rotate OFF
Origin
* The pairs of arrows indicate the positive directions along the X and Y axis.
Check that the SETUP LED has
gone out, and press the ROTATE
key.
* If the SETUP LED is lit up, the
Rotate function is disabled and will
not work.
Press the SETUP key to extinguish
the SETUP LED, then press the
ROTATE key again.
Send cutting data from the computer.
Canceling the Rotate Function
After holding down the SETUP key for about one second to make the SETUP LED go out, press the ROTATE key. The ROTATE LED
is extinguished, and the origin returns to the point at bottom left.
The ROTATE function is also canceled when the power to the PNC-960/910 is turned off.
Press the SETUP key.
The SETUP LED lights up and the
The ROTATE LED
lights up
tool carriage moves to the left and
right, then returns.
1 1
1
3 3
3
4 Settings For Each Function
90° Rotation - Rotate ON
The SETUP LED
lights up
Origin
2 2
2
15