Skoda Kodiaq 2017 Workshop Manual page 76

Kodiaq 2017 ➤ , Kodiaq 2019 ➤
Brake systems - Edition 11.2018
1 - Bearing bracket
❑ Removing and installing
⇒ "4.2 Removing and in‐
stalling bearing brack‐
et", page 75
2 - Nut
❑ self-locking
❑ Replace after disas‐
sembly
❑ Observe tightening se‐
quence
⇒ Fig. ""Order of tighten‐
ing"" , page 73
❑ 25 Nm
3 - Retaining clip
❑ Replace after disas‐
sembly
❑ inserted into both bear‐
ing bracket bore holes
4 - Bushing
Note
Note installation position.
5 - Cap
6 - Brake pedal
❑ Assignment ⇒ Electron‐
ic Catalogue of Original
Parts
7 - Bearing shell
8 - Support
❑ for ball head of pressure
rod of brake servo unit
9 - Bearing shaft
❑ Replace after disassembly
❑ removing:
– Removing bracket
– Turn bearing bolts anti-clockwise, the bearing bolt catches will break off.
– Pull out bearing bolt.
Note
Do not grease the bearing bolt. The
bearing bolt must remain dry.
❑ installation is carried out in reverse order
Note
The screw for the bearing bolt must
click audibly into place when tight‐
ening.
72
Rep. gr.46 - Brakes - mechanism
Volkswagen Technical Site: http://vwts.ru http://vwts.info
⇒ "4.2 Removing and installing bearing bracket", page 75