Skoda Kodiaq 2017 Workshop Manual page 61

1 - Cover plate
❑ Removing and installing
⇒ "2.5 Removing and in‐
stalling brake shield
plate", page 67
❑ Assignment ⇒ Electron‐
ic Catalogue of Original
Parts
2 - Screw
❑ 12 Nm
3 - Brake disc
❑ internally ventilated
❑ Dimensions and wear
limit
⇒ "3.1 Technical data for
brakes", page 3
❑ always replace axle-
wise
❑ Do not use force to sep‐
arate the brake discs
from the wheel hub, if
necessary use rust sol‐
vent; as you could oth‐
erwise damage the
brake discs.
❑ Removing and installing
⇒ "2.4 Removing and in‐
stalling brake disc",
page 66
❑ Assignment ⇒ Electron‐
ic Catalogue of Original
Parts
4 - Screw
❑ 8 Nm
5 - Brake caliper
❑ do not unscrew the brake hose when replacing the brake pad
❑ Removing and installing
❑ Observe the instructions for changing the pad
⇒ "2.2.1 Changing the brake pads of the rear brake - Mounting instructions", page 58
6 - Screw
❑ Replace after disassembly
❑ 90 Nm + 90°.
7 - Brake carrier
8 - Spring
9 - Outer brake pad
❑ Dimensions and wear limit
❑ always replace axle-wise
❑ Removing and installing
❑ Observe the instructions for changing the pad
⇒ "2.2.1 Changing the brake pads of the rear brake - Mounting instructions", page 58
10 - Inner brake pad
❑ Dimensions and wear limit
❑ always replace axle-wise
❑ Removing and installing
⇒ "2.3 Removing and installing brake caliper, rear brake", page 62
⇒ "3.1 Technical data for brakes", page 3
⇒ "2.2 Removing and installing brake pads", page 58
⇒ "3.1 Technical data for brakes", page 3
⇒ "2.2 Removing and installing brake pads", page 58
Kodiaq 2017 ➤ , Kodiaq 2019 ➤
Brake systems - Edition 11.2018
57
2. Rear brakes