2
Rear brake caliper
⇒ "2.1 Summary of components - rear brake caliper", page 85
⇒ "2.2 Removing and installing protective cover", page 86
2.1
Summary of components - rear brake caliper
Note
Replace bolts / nuts that are tightened at an angle of rotation, as well as replacement components after
♦
removal.
Install the complete repair set when undertaking repairs.
♦
Use only methylated spirit for cleaning.
♦
Thinly coat brake cylinder, piston and gasket ring with lithium grease - G 052 150 A2- .
♦
1 - Brake caliper housing
❑ replace brake caliper
housing if the lever for
the handbrake cable is
not sealed
2 - Damping sleeve
3 - Guide bolt
4 - Cap
5 - Screw
❑ Tightening torque
⇒ "2.1 Assembly over‐
view - rear brakes",
page 56
6 - Handbrake motor
❑ Removing and installing
⇒ "3.3 Removing and in‐
stalling handbrake mo‐
tor V282 / V283 ",
page 69
7 - Sealing ring
❑ Replace after disas‐
sembly
8 - Compressor nut
❑ Cannot be removed
9 - Sealing ring
❑ Cannot be removed
10 - Piston
❑ Cannot be removed
11 - Boot
❑ Removing and installing
⇒ "2.2 Removing and in‐
stalling protective cover", page 86
12 - Vent valve
❑ thinly coat thread with lithium grease - G 052 150 A2- before screwing in
❑ 10 Nm
Kodiaq 2017 ➤ , Kodiaq 2019 ➤
Brake systems - Edition 11.2018
2. Rear brake caliper
85