Senders And Sensors; Removing And Installing Intake Manifold Pressure Sender Gx9; Removing And Installing Fuel Pressure Sender G247 - Skoda Octavia III 2013 Workshop Manual

5

Senders and sensors

⇒ "5.1 Removing and installing intake manifold pressure sender
GX9 ", page 257
⇒ "5.2 Removing and installing fuel pressure sender G247 ", page
257
⇒ "5.3 Check fuel pressure sender G247 ", page 258
5.1 Removing and installing intake manifold
pressure sender - GX9-
The charge pressure sender - GX9- consists:
♦ Intake air temperature sender 2 - G299-
♦ Intake manifold pressure sender - G71-
Removing
– Remove air filter housing
⇒ "2.2 Removing and installing air filter housing", page 239
– Disconnect plug connection -arrow-.
– Unlock locking tabs, remove the manifold pressure sender -
GX9- .
Install
Installation is carried out in the reverse order. When installing,
observe the following:
Note
Renew O-ring.
♦
If retaining tabs break during removal, fixing screws can be
♦
attached to the sender as a replacement ⇒ Electronic Cata‐
logue of Original Parts"ETKA" .
– Install air filter housing
⇒ "2.2 Removing and installing air filter housing", page 239
Tightening torque
Component
Intake manifold pressure sender -
GX9-
5.2 Removing and installing fuel pressure
sender - G247-
Special tools and workshop equipment required
♦ Assembly tool - T10118-
♦ Socket insert size 27 - T40218- or commercially available
27 mm socket insert
Octavia III 2013 ➤ , Octavia III 2014 ➤
1.2/63; 77 kW TSI engine - Edition 11.2014
.
.
Nm
3 Nm
257
5. Senders and sensors