Skoda Kodiaq 2017 Workshop Manual page 100

Kodiaq 2017 ➤ , Kodiaq 2019 ➤
Brake systems - Edition 11.2018
– Release the nuts -3- and -4-.
– Carefully remove the brake servo unit from the vehicle.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
– Clip the brake pedal onto the brake servo
⇒ "4.4 Clipping the brake pedal onto the brake servo unit",
page 80 .
– Fill up with new brake fluid.
– Bleed brake system
⇒ "6.3 Bleeding hydraulic system following standard proce‐
dure", page 125 .
Vehicles fitted with a manual gearbox
– Bleed the clutch ⇒ Rep. gr. 30 ; Clutch mechanism; Bleed the
clutch mechanism .
Tightening torques - summaries of components
Note
Replace bolts / nuts that are tightened at an angle of rotation, as
well as replacement components after removal.
♦ ⇒ "3.1.1 Summary of components - brake servo unit/master
brake cylinder, left-hand drive vehicles", page 88
♦ ⇒ "4.1.1 Summary of components - brake pedal, left-hand
drive", page 71
♦ Knee airbag ⇒ General body repairs, interior; Rep. gr. 69 ;
Knee airbags; Summary of components - knee airbag
3.3.2 Removing and installing brake booster,
left-hand drive with Bi-Turbo diesel en‐
gine
Special tools and workshop equipment required
♦ Brake filling and bleeding device , e. g. -VAS 5234-
♦ Extraction bottle (commercially available)
♦ Repair kit - 1H0 698 311 A-
Removing
– Disconnect battery earth strap ⇒ Electrical system; Rep. gr.
27 ; Battery; Disconnecting and connecting battery .
– Remove master brake cylinder
⇒ "3.4 Removing and installing master brake cylinder",
page 102 .
– Remove holder for the air filter housing ⇒ Rep. gr. 23 ; Air
filter; Removing and installing air filter housing .
– By pressing the brake pedal several times, eliminate the vac‐
uum in the brake servo unit.
96
Rep. gr.47 - Brakes - hydraulics