Skoda Kodiaq 2017 Workshop Manual page 29

– Position brake pedal load , e.g. -V.A.G 1869/2- .
– Attach the bleeder hose of the bleeding bottle onto the vent
valves of the front left and rear left brake caliper and open vent
valves.
– Press down brake pedal with brake pedal load , e.g. -V.A.G
1869/2- , at least 60 mm.
– Close front left and rear left bleeder valves.
– Do not remove brake pedal load , e. g. -V.A.G 1869/2- .
– Place a sufficient non-fluffing cloths under and around the ABS
control unit - J104- and the ABS hydraulic unit - N55- .
NOTICE
Make sure that no brake fluid gets onto the contacts of the ABS
control unit - J104- .
– Detach the top section of the heat-protection matting on the
front wall and shift to side.
– Clip the brake lines off the two mounting brackets.
– Mark both brake lines -5- and -6- (from the master brake cyl‐
inder) and unscrew from the ABS hydraulic unit - N55- .
– Close the brake lines and threaded holes immediately with
plugs from the repair kit - 1H0 698 311 A- .
– Mark the brake lines (for brake calliper) -1- to -4-, unscrew and
close with plugs from the repair kit - 1H0 698 311 A- .
– Pull the ABS hydraulic unit - N55- and the ABS control unit -
J104- -1- in the -direction of the arrow- and out of the shock
absorbers.
Kodiaq 2017 ➤ , Kodiaq 2019 ➤
Brake systems - Edition 11.2018
3. Control unit and hydraulic unit
25