Skoda Kodiaq 2017 Workshop Manual page 34

Kodiaq 2017 ➤ , Kodiaq 2019 ➤
Brake systems - Edition 11.2018
– Fit engine support bracket - T10533- to gearbox and assembly
carrier as per figure (N23-10646).
– Press the engine with gearbox forwards using the support
bracket - T10533- .
– Remove nuts -arrows- and holder -1- of the ABS hydraulic unit
- N55- with the control unit for ABS - J104- from the vehicle.
– Remove the ABS hydraulic unit - N55- and the ABS control
unit - J104- at the bottom from the vehicle.
Note
If the ABS hydraulic unit - N55- is damaged, the ABS control
♦
unit - J104- must be fully replaced with the ABS hydraulic unit
- N55- .
The ABS control unit - J104- can be separated from the ABS
♦
hydraulic unit - N55-
⇒ "3.3 Disconnecting the control unit from the hydraulic unit",
page 34 .
The hydraulic pump and the ABS hydraulic unit - N55- must
♦
not be separated from each other.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
Note
Only remove plugs from the new ABS hydraulic unit - N55- if
♦
the relevant brake line is installed.
If the plugs were already removed from the ABS hydraulic unit
♦
- N55- , then brake fluid may escape and adequate filling and
bleeding of the unit can no longer be guaranteed.
Make sure that the rubber bearings are not pressed out of the
♦
console when installing the bracket. After installing, check for
tight fight, otherwise failure may be caused by a malfunction
of the ABS hydraulic unit - N55- .
– Observe the tightening sequence of the brake lines
⇒ Fig. ""Tightening sequence of the brake lines"" ,
page 31 .
– Remove brake pedal load e.g. -V.A.G 1869/2- .
– Bleed brake system.
– Code the control unit - J104- ⇒ Vehicle diagnostic tester.
While doing so, a basic setting of the steering angle sender -
G85- , the lateral acceleration sender - G200- , the brake pressure
sender 1 - G201- and the longitudinal acceleration sender - G251-
must be performed ⇒ Vehicle diagnostic tester.
30
Rep. gr.45 - Anti-lock brake system