Skoda Kodiaq 2017 Workshop Manual page 69

– Remove caps -arrows-.
– Remove both guide pins from the brake caliper with extension
(No. 7) - T10503- .
– Pull off brake caliper from brake carrier.
Clean
WARNING
Do not flush the brake system with compressed air. The dust
that is generated is hazardous to health!
– Thoroughly clean guiding surface for brake pads on brake
carrier and remove corrosion.
– Clean brake caliper.
Note
Use spirits only to clean the brake caliper housing.
Installing
Note
Observe the instructions for changing the pad
♦
⇒ "2.2.1 Changing the brake pads of the rear brake - Mounting
instructions", page 58
The adherend for the brake pads must be free from glue res‐
♦
idues and grease.
Drain the brake fluid from the brake fluid reservoir using a
♦
ventilation bottle before resetting the piston. Otherwise, par‐
ticularly if reservoir has been topped up, fluid will overflow and
cause damage.
Do not operate the handbrake for any reason! If the handbrake
♦
is operated, the brake caliper is permanently damaged.
CAUTION
Brake fluid is toxic and must never be sucked up by mouth!
• The brake pads are fitted in the retaining springs on the brake
caliper.
– Fit brake caliper to the brake carrier.
– Install both brake caliper guide pins.
– Install handbrake motor
⇒ "3.3 Removing and installing handbrake motor V282 / V283
", page 69 .
– Bolt brake hose to brake caliper.
– Bleed brake system
⇒ "6.3 Bleeding hydraulic system following standard proce‐
dure", page 125 .
– Perform basic setting of the brake system with the ⇒ Vehicle
diagnostic tester.
– Attach the wheels.
.
Kodiaq 2017 ➤ , Kodiaq 2019 ➤
Brake systems - Edition 11.2018
65
2. Rear brakes