Kodiaq 2017 ➤ , Kodiaq 2019 ➤
Brake systems - Edition 11.2018
– Start by bolting the ABS control unit - J104- to the ABS hy‐
draulic unit - N55- by hand using new screws -arrows-.
Note
A new ABS control unit - J104- may only be installed on the
♦
remaining ABD hydraulic unit - N55- a maximum of three times
in order to ensure leak-tightness of the elastic seal.
If the ABS control unit - J104- has already been installed and
♦
used in the vehicle, it must not be installed a second time.
The threads in the ABS hydraulic unit - N55- must not be re‐
♦
paired or recut.
If the thread is damaged, the ABS hydraulic unit - N55- must
♦
be replaced.
– Tighten the screws in two stages
⇒ "3.1 Exploded view – control unit and hydraulic unit",
page 15
.
3.5
Connecting brake lines to hydraulic unit
⇒ "3.5.1 Connect the brake lines to the hydraulic unit, left-hand
drive vehicle", page 36
⇒ "3.5.2 Connect the brake lines to the hydraulic unit, right-hand
drive vehicle", page 37
3.5.1
Connect the brake lines to the hydraulic
unit, left-hand drive vehicle
At brake master cylinder
A - Primary piston circuit of brake master cylinder to ABS hy‐
draulic unit - N55-
- Distinguishing feature: ∅ 6 mm and pipe screw with thread M 12
x 1
B - Secondary piston circuit of brake master cylinder to ABS hy‐
draulic unit - N55-
- Distinguishing feature: ∅ 6 mm and pipe screw with thread M 12
x 1
1 - from the ABS hydraulic unit - N55- to the front left brake caliper
2 - from the ABS hydraulic unit - N55- to the rear right brake caliper
3 - from the ABS hydraulic unit - N55- to the rear left brake caliper
36
Rep. gr.45 - Anti-lock brake system