Skoda Kodiaq 2017 Workshop Manual page 48

Kodiaq 2017 ➤ , Kodiaq 2019 ➤
Brake systems - Edition 11.2018
– Disconnect plug -1- on the rear speed sensor - G44- / -G46- .
– Remove screw -2-.
– Pull the rear speed sensor - G44- / -G46- out of the axle stud
and brake carrier.
Installing
– Installation is carried out in the reverse order.
Tightening torques - summaries of components
Note
Replace bolts / nuts that are tightened at an angle of rotation, as
well as replacement components after removal.
♦ ⇒ "4.2 Assembly overview - speed sensor on rear axle", page
41
4.7.2 Removing and installing rear speed sen‐
sors -G44- / -G46- , vehicles with four-
wheel drive
Removing
– Raise vehicle.
– Disconnect plug -3- on the rear speed sensor - G44- / -G46- .
– Remove screw -2-.
– Pull rear speed sensor - G44- / -G46- -1- out of the wheel
bearing housing.
Installing
– Installation is carried out in the reverse order.
Tightening torques - summaries of components
Note
Replace bolts / nuts that are tightened at an angle of rotation, as
well as replacement components after removal.
♦ ⇒ "4.2 Assembly overview - speed sensor on rear axle", page
41
44
Rep. gr.45 - Anti-lock brake system