♦ Vehicle diagnosis, measurement and information system
♦ Brake filling and bleeding device , e. g. -VAS 5234-
♦ Brake pedal load , e.g. -V.A.G 1869/2-
♦ Extension piece (No. 7) - T10503-
♦ Bleeding bottle (commercially available)
♦ Braking fluid ⇒ Electronic Catalogue of Original Parts
Removing
Note
This procedure applies only to exchanging or the following re‐
♦
pair work on the brake caliper.
Observe the instructions for changing the pad
♦
⇒ "1.2.1 Changing the brake pads of the front brake - Mounting
instructions", page 47
When removing mark the brake pads (inner, outer) you intend
♦
to keep using. Fit in same position when installing, or braking
will be uneven!
Do not disconnect the connectors of the handbrake motor.
♦
The adherend for the brake pads must be free from glue res‐
♦
idues and grease.
Drain the brake fluid from the brake fluid reservoir using a
♦
ventilation bottle before resetting the piston. Otherwise, par‐
ticularly if reservoir has been topped up, fluid will overflow and
cause damage.
♦
Do not unscrew the brake hose when replacing the brake pad.
Do not operate the handbrake for any reason! If the handbrake
♦
is operated, the brake caliper is permanently damaged.
CAUTION
Brake fluid is toxic and must never be sucked up by mouth!
•
Electronic handbrake not actuated.
– Remove wheels.
– Reset the pistons for the electronic handbrake ⇒ Vehicle di‐
agnostic tester.
– Remove handbrake motor
⇒ "3.3 Removing and installing handbrake motor V282 / V283
", page 69
.
– Fit the bleeder hose of the bleeding bottle -1- onto the bleeder
valve and release bleeder valve.
.
Kodiaq 2017 ➤ , Kodiaq 2019 ➤
Brake systems - Edition 11.2018
63
2. Rear brakes