Skoda Kodiaq 2017 Workshop Manual page 65

– Remove brake pads -2- and -3-.
Clean
WARNING
Do not flush the brake system with compressed air. The dust
that is generated is hazardous to health!
– Thoroughly clean guiding surface for brake pads on brake
carrier and remove corrosion.
– Clean brake caliper.
Note
Use spirits only to clean the brake caliper housing.
Installing
Note
Observe the instructions for changing the pad
♦
⇒ "2.2.1 Changing the brake pads of the rear brake - Mounting
instructions", page 58
The adherend for the brake pads must be free from glue res‐
♦
idues and grease.
Drain the brake fluid from the brake fluid reservoir using a
♦
ventilation bottle before resetting the piston. Otherwise, par‐
ticularly if reservoir has been topped up, fluid will overflow and
cause damage.
Do not operate the handbrake for any reason! If the handbrake
♦
is operated, the brake caliper is permanently damaged.
CAUTION
Brake fluid is toxic and must never be sucked up by mouth!
– Push the brake caliper piston with the piston reset device -
T10145- to the default setting.
– Grease the guiding surface for brake pads on brake carrier
with grease G 052 A2.
.
Kodiaq 2017 ➤ , Kodiaq 2019 ➤
Brake systems - Edition 11.2018
61
2. Rear brakes