Fitting The Control Unit To The Hydraulic Unit - Skoda Kodiaq 2017 Workshop Manual

– Separate the ABS control unit - J104- from the ABS hydraulic
unit - N55- in the -direction of arrow-.
Note
The ABS control unit - J104- may not tilt when it is pulled off from
the ABS hydraulic unit - N55- .
– Cover the solenoid coils of the ABS control unit - J104- with a
non-fluffing cloth.
After separating from the ABS control unit - J104- and the ABS
hydraulic unit - N55- , use the transport protection for valve
domes.
– Check the sealing surface of the ABS hydraulic unit - N55- for
cleanliness. If necessary clean with white spirits and a non-
fluffing cloth.
Note
The sealing surface of the ABS control unit - J104- may not be
♦
repaired using a file, metal scraper or similar.
If the sealing surface is damaged, replace the sealing surface
♦
of the ABS control unit - J104- .
The seal of the ABS control unit - J104- must not be damaged.
♦
The seal is not designed as spare part, so it is part of the new
♦
ABS control unit - J104- .
3.4 Fitting the control unit to the hydraulic
unit
Note
Strong vibrations (e.g. fall, knock) can destroy the ABS control
unit - J104- . The ABS control unit - J104- must no longer be used.
• The contact surfaces must be cleaned before assembling.
• The seal of the ABS control unit - J104- must not be damaged.
– Position the ABS control unit - J104- without tilting it onto the
ABS hydraulic unit - N55- .
Kodiaq 2017 ➤ , Kodiaq 2019 ➤
Brake systems - Edition 11.2018
3. Control unit and hydraulic unit
35