Skoda Kodiaq 2017 Workshop Manual page 102

Kodiaq 2017 ➤ , Kodiaq 2019 ➤
Brake systems - Edition 11.2018
– Release the nuts -3- and -4-.
– Carefully remove the brake servo unit from the vehicle.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
– Clip the brake pedal onto the brake servo
⇒ "4.4 Clipping the brake pedal onto the brake servo unit",
page 80 .
– Fill up with new brake fluid.
– Bleed brake system
⇒ "6.3 Bleeding hydraulic system following standard proce‐
dure", page 125 .
Vehicles fitted with a manual gearbox
– Bleed the clutch ⇒ Rep. gr. 30 ; Clutch mechanism; Bleed the
clutch mechanism .
Tightening torques - summaries of components
Note
Replace bolts / nuts that are tightened at an angle of rotation, as
well as replacement components after removal.
♦ ⇒ "3.1.1 Summary of components - brake servo unit/master
brake cylinder, left-hand drive vehicles", page 88
♦ ⇒ "4.1.1 Summary of components - brake pedal, left-hand
drive", page 71
♦ Knee airbag ⇒ General body repairs, interior; Rep. gr. 69 ;
Knee airbags; Summary of components - knee airbag
3.3.3 Removing and installing brake servo,
right-hand drive with diesel engine
Special tools and workshop equipment required
♦ Brake filling and bleeding device , e. g. -VAS 5234-
♦ Extraction bottle (commercially available)
♦ Repair kit - 1H0 698 311 A-
Removing
Vehicles with exhaust gas cleaning module
– Remove exhaust gas cleaning module ⇒ Rep. gr. 26 ; Ex‐
haust gas cleaning; removing and installing exhaust gas
cleaning module .
Continued for all vehicles
Note
Repairs may only be carried out in specialist service centres
which have suitably trained personnel and are fitted out for work‐
ing on the refrigerant circuit.
– Empty the refrigerant circuit with the aid of the A/C service
station .
98
Rep. gr.47 - Brakes - hydraulics