Removing And Installing Control Unit For Electronic Handbrake J540; Removing And Installing Handbrake Motor V282 / V283 - Skoda Kodiaq 2017 Workshop Manual

4 - Sealing ring
❑ Replace after disassembly
5 - Parking motor on the left - V282-
❑ Fitting location: on rear left brake caliper
❑ Removing and installing
6 - Screw
❑ 12 Nm
7 - Right parking motor - V283-
❑ Fitting location: on rear right brake caliper
❑ Removing and installing
3.2 Removing and installing control unit for
electronic handbrake - J540-
It is not possible to remove these parts separately.
Control unit for electronic handbrake - J540- integrated into the
ABS control unit - J104-
⇒ "3.2 Removing and installing ABS control unit J104 / ABS
hydraulic unit N55 ", page 19
3.3 Removing and installing handbrake mo‐
tor -V282- / -V283-
Special tools and workshop equipment required
♦ Vehicle diagnosis tester
Removing
Note
The ignition must be switched off for at least 30 seconds before
disconnecting the connector.
– Pull connector -1- off the handbrake motor.
– Remove screws -arrows- of the handbrake motor.
– Pull the handbrake motor off the brake caliper, turning the
handbrake motor back and forth slightly as you do so.
⇒ "3.3 Removing and installing handbrake motor V282 / V283 ", page 69
⇒ "3.3 Removing and installing handbrake motor V282 / V283 ", page 69
.
Kodiaq 2017 ➤ , Kodiaq 2019 ➤
Brake systems - Edition 11.2018
69
3. Handbrake