Skoda Kodiaq 2017 Workshop Manual page 81

– Release the nuts -1- to -4-.
– Detach all the electrical cables from the bearing bracket.
– Remove bracket.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
– Clip the brake pedal onto the brake servo
⇒ "4.4 Clipping the brake pedal onto the brake servo unit",
page 80 .
– Observe tightening sequence
⇒ Fig. ""Order of tightening"" , page 73
Tightening torques - summaries of components
Note
Replace bolts / nuts that are tightened at an angle of rotation, as
well as replacement components after removal.
♦ ⇒ "4.1.1 Summary of components - brake pedal, left-hand
drive", page 71
♦ Impact absorber ⇒ General body repairs, interior; Rep. gr.
70 ; Dash panel cross member
♦ Knee airbag ⇒ General body repairs, interior; Rep. gr. 69 ;
Knee airbags; Removing and installing knee airbag with igniter
♦ Accelerator pedal ⇒ Rep. gr. 20 ; Accelerator control
4.2.2 Removing and installing bearing brack‐
et, right-hand drive vehicles
– Remove windscreen wiper motor with linkage ⇒ Electrical
system; Rep. gr. 92 ; Windscreen wiper system; Removing
and installing windscreen wiper motor - V- .
– Remove screw -1-.
– Remove knee airbag ⇒ Interior body work; Rep. gr. 69 ; Knee
airbags; removing and installing knee airbag with ignition
– Remove the driver side footwell vent ⇒ Heating system, air
conditioning system; Rep. gr. 87 ; Air duct; Remove and install
driver side footwell vent .
– Remove impact absorber ⇒ General body repairs, interior;
Rep. gr. 70 ; Dash panel cross member .
– Remove the accelerator pedal ⇒ Rep. gr. 20 ; throttle control .
Kodiaq 2017 ➤ , Kodiaq 2019 ➤
Brake systems - Edition 11.2018
77
4. Brake pedal