Skoda Kodiaq 2017 Workshop Manual page 32

Kodiaq 2017 ➤ , Kodiaq 2019 ➤
Brake systems - Edition 11.2018
The ABS control unit - J104- is bolted to the ABS hydraulic unit -
N55- and is located in the engine compartment on the right side.
Note
Do not bend the brake lines in the area of the hydraulic unit.
– Read out and note the actual control unit coding.
– Disconnect battery earth strap ⇒ Electrical system; Rep. gr.
27 ; Battery; Disconnecting and connecting battery .
– Remove the noise insulation ⇒ General body repairs, exterior;
Rep. gr. 66 ; Noise insulation; Summary of components -
noise insulation .
– If present, remove the axle cover.
– Remove the coupling rod ⇒ Rep. gr. 10 ; Powertrain mount‐
ing; remove and install coupling rod .
– Remove the exhaust front pipe ⇒ Rep. gr. 26 ; Exhaust pipe/
silencer .
– Remove propshaft from front gearbox and place to one side
⇒ Rep. gr. 39 ; Propshaft; Removing and installing propshaft .
– Remove heat shield -1-, if present.
– Unclip the wiring, if available.
– Unlock the fuse plug -1- in direction of arrow -A- and pull it off
the ABS control unit - J104- in direction of arrow -B-.
28
Rep. gr.45 - Anti-lock brake system