Skoda Kodiaq 2017 Workshop Manual page 74

Kodiaq 2017 ➤ , Kodiaq 2019 ➤
Brake systems - Edition 11.2018
– Take out sealing ring.
Note
Make sure that the annular groove of the sealing ring and the
contact surface of the handbrake motor are not damaged.
– Clean the annular groove and the contact surface of the hand‐
brake motor.
Installing
– Lightly grease the new sealing ring and install it, ensuring that
the sealing ring is kept straight and not damaged.
– Fully grease the drive shaft of the handbrake motor.
Note
The sealing ring must not be twisted out while assembling the
handbrake motor!
– Carefully slide the handbrake motor onto the brake caliper,
while ensuring that the sealing ring is seated correctly.
Note
If necessary, drive back the drive shaft slightly with an E11 Torx
insert -A- so that you can position the handbrake motor correctly.
– Twist the handbrake motor until the screw holes and thread
are aligned.
Note
Make sure the handbrake motor is in contact with the brake cali‐
per. Do not tighten the screws if the handbrake motor is not in
contact with the brake caliper.
– Screw in the screws -arrow-.
– Connect connector -1-.
– Bring the brake system to basic position ⇒ Vehicle diagnostic
tester.
Tightening torques - summaries of components
Note
Replace bolts / nuts that are tightened at an angle of rotation, as
well as replacement components after removal.
♦ ⇒ "3.1 Assembly overview - parking brake", page 68
70
Rep. gr.46 - Brakes - mechanism