Check The Parking Brake - Skoda Kodiaq 2017 Workshop Manual

Kodiaq 2017 ➤ , Kodiaq 2019 ➤
Brake systems - Edition 11.2018
– Start engine and wait approx. 5 seconds until adequate vac‐
uum has built up.
4.4

Check the parking brake

⇒ "4.4.1 Check electromechanical parking brake, vehicles with
front drive", page 8
⇒ "4.4.2 Check electromechanical parking brake, vehicles with
all-wheel drive", page 8
4.4.1 Check electromechanical parking
brake, vehicles with front drive
Enable »MOT mode«
• Safety belt is installed.
• Rear axle is on the 1-axle roller test stand
• Ignition is switched on.
• »Auto Hold« is switched off.
• Front wheels must be stationary.
• The rear wheels must rotate constantly between 2.5 and 9 km /
h for at least 5 seconds.
Enabled »MOT mode« is signalled by the yellow Electric parking
and handbrake fault lamp - K214- lighting up.
Note
The electromechanical parking brake does not fully close in
»MOT mode« when the button for the electromechanical parking
brake - E538- is pressed for the first time.
After the Button for the electromechanical parking brake - E538-
is pressed four times in succession, the parking brake fuly locks.
Pressing the button for the electromechanical parking brake -
E538- leads to the electromechanical parking brake being re‐
leased.
End »MOT mode«
• Front wheels have a speed greater than 0 km / h.
• Rear wheels have a speed less than 2.5 km / h or greater than
9 km / h.
• The ignition is switched off.
4.4.2 Check electromechanical parking
brake, vehicles with all-wheel drive
Enable »MOT mode«
• Safety belt is installed.
• Rear axle is on the 1-axle roller test stand
• Ignition is switched on.
• »Auto Hold« is switched off.
• Front wheels must be stationary.
• The rear wheels must rotate constantly between 2.5 and 9 km /
h for at least 5 seconds.
8