Nortel 3050 Command Reference Manual page 96

96 Command Reference
Table 23
Trace Menu Options (/cfg/ssl/server/trace) (cont'd.)
Command Syntax and Usage
traceroute <host name or IP address of target station >
/cfg/ssl/server <id> /ssl SSL Settings Configuration
[SSL Settings Menu]
cert - Set server certificate
cache size -Set SSL cache size
cachettl - Set SSL cache timeout
cacerts - Set list of accepted signers of client certificates
cachain - Set list of CA chain certificates
protocol - Set protocol version
verify - Set certificate verification level
ciphers - Set cipher list
ena - Enable SSL
dis - Disable SSL
Copyright © 2007 Nortel Networks
.
Use this command to find the IP address or host name of a machine.
If a backend interface is mapped to the current virtual SSL server (only
possible for socks servers), the check is made through that backend
interface. If a DNS server is configured for the current virtual SSL
server, the check is made against that DNS server.
To map a backend interface to the virtual SSL server, use the
/cfg/ssl/server #/interface command. To configure a
DNS server for the virtual SSL server, use the /cfg/ssl /server
#/dns/servers command.
Use this command to identify the route used for station-to-station
connectivity across the network. If a backend interface is mapped to the
current virtual SSL server (only possible for socks servers), the check is
made through that backend interface.
To map a backend interface to the virtual SSL server, use the
/cfg/ssl/server #/interface command.
To be able to use a host name, the DNS parameters must be
configured. To configure a DNS server for the virtual SSL server, use
the /cfg/ssl/server #/dns/servers command or use the default
DNS server (/cfg/sys/dns).
Nortel VPN Gateway
Command Reference
NN46120-103 01.01 Standard
10 September 2007