Nortel 3050 Command Reference Manual page 140

140 Command Reference
Table 38
Health Check Script Menu Options (/cfg/ssl/server/adv/loadbalanc /script) (cont'd.)
Command Syntax and Usage
move <index number to move> <destination index number>
/cfg/ssl/server <id> /adv/loadbalanc /remotessl Remote
SSL Connect Configuration
[Remote SSL Connect Settings Menu]
protocol - Set protocol version
cert - Set client certificate
ciphers - Set accepted ciphers for SSL connect
verify - Verify server menu
The Remote SSL Connect Settings menu is used for configuring the
SSL protocol, the preferred cipher list, and client authentication for SSL
connections between the VPN Gateway(s) and the backend servers.
Table 39
Remote SSL Connect Settings Menu Options (/cfg/ssl/server/adv/loadbalanc
/remotessl)
Command Syntax and Usage
protocol ssl2|ssl3|ssl23|tls1
cert <client certificate by index number>
Copyright © 2007 Nortel Networks
.
Lets you move a script line up or down in the health check script. The
script commands are processed one after the other, starting from the
lowest index number and ending with the highest index number.
To view all lines and script commands in the script, use the list
command.
Specifies the protocol the virtual SSL server should propose when
establishing an SSL session with an SSL-enabled backend server.
Valid options are:
•
ssl2: Propose using only SSL 2.0.
•
ssl3: Propose using SSL 3.0 or TLS 1.0.
•
ssl23: Propose using any of SSL 2.0, SSL 3.0, or TLS 1.0.
•
tls1: Propose using only TLS 1.0.
The default protocol value is ssl3.
Nortel VPN Gateway
Command Reference
NN46120-103 01.01 Standard
10 September 2007