Nortel 3050 Command Reference Manual page 90

90 Command Reference
del - Remove virtual server
ena - Enable virtual server
dis
- Disable virtual server
The SSL Server menu is used for configuring various attributes of a
particular virtual SSL server. The number of items available in the menu
will vary according to the virtual SSL server type (generic, http or socks).
When accessing the SSL Server menu, you are requested to specify the
index number of the virtual SSL server you want to work with. To view
information about all configured SSL servers, use the /info/servers
command.
Table 22
SSL Server Configuration Menu Options (/cfg/ssl/server)
Command Syntax and Usage
name <SSL server name>
vips <virtual server IP addresses separated by comma>
standalone on|off
Copyright © 2007 Nortel Networks
.
Assigns a name to the virtual SSL server. The assigned name is mainly
for your own reference.
"" is the default value. You cannot enter only numerals as server name.
Sets the virtual server IP address (on the Nortel Application Switch), to
which the virtual SSL server is mapped. For example: 10,127,232,48.
If the VPN Gateway is used without a Nortel Application Switch
(standalone mode), several IP addresses can be specified to
create a solution where two or more VPN Gateways in a cluster are
load-balanced by the DNS server. For configuration examples in
standalone mode, see the "Stand-alone Web Server Accelerator"
chapter in the Application Guide for SSL Acceleration.
•
on: When set to on, the VPN Gateway operates in standalone
mode, i.e. it is not connected to an Nortel Application Switch.
Clients connect directly to one of the virtual SSL server's IP
addresses, configured with the vips command. For configuration
examples in standalone mode, see the "Stand-alone Web Server
Accelerator" chapter in the Application Guide for SSL Acceleration.
•
off: When set to off, the VPN Gateway is connected to an Nortel
Application Switch for SSL offload purposes. The IP address set
with the vips command corresponds to a virtual IP address on the
Nortel Application Switch.
The default value is off.
Nortel VPN Gateway
Command Reference
NN46120-103 01.01 Standard
10 September 2007