420 Command Reference
You can control the mobility by enabling or disabling mobility per VPN
or per group and setting maximum roaming time. Client tries connecting
immediately on detecting a link state change. This can be done using the
command cfg/vpn 1/sslclient/mobility.
Table 170
Mobility Menu (cfg/vpn 1/sslclient/mobility)
Command usage syntax
roaming [ena/dis/group]
Specifies if mobility is enabled or disabled per VPN or per group.
roamtime [1min – 24 hours]
Specifies the maximum mobility roam time that needs to be set. Default is 5 mins.
cfg/vpn #/sslclient/mobility/roamnetsMobility roaming
networks
[roamnets menu]
list - List all values
add - Add a new value
del - Delete a value by a number
The NetDirect session remains in the UP state even when the physical
link and NetDirect session is down. If a link is temporarily disconnected in
client side, mobility media status notifications waits till maximum roaming
time set. The maximum number of roamnets is 32.
Table 171
Mobility Menu (cfg/vpn 1/sslclient/mobility)
Command usage syntax
list
Lists all roaming networks.
add
Adds a roaming network
del
Deletes a roaming network.
/cfg/vpn #/sslclient/advRoute table monitoring
[Route table monitoring menu]
routemon - Set the route table monitoring behavior on client.
Copyright © 2007 Nortel Networks
.
Note:
Only roaming and roamtime can be configured on group basis.
Nortel VPN Gateway
Command Reference
NN46120-103 01.01 Standard
10 September 2007