Nortel 3050 Command Reference Manual page 475

/maint/hsm Hardware Security Module Menu
[HSM Menu]
login- Login to HSM cards on local iSD
splitkey - Split a wrap key onto CODE iKeys
changepass - Change iKey password
The HSM menu is used for logging in to the HSM card on a local ASA
310-FIPS device after a reboot has occurred. It is also used for splitting
the wrap key onto a set of HSM-CODE iKeys. Note that the HSM menu is
only accessible if you are using the ASA 310-FIPS model.
Table 211
HSM Menu Options (/maint/hsm)
Command Syntax and Usage
login <HSM-USER password for the currently inserted HSM-USER
iKey>
splitkey
Copyright © 2007 Nortel Networks
.
Lets you log in to a HSM card, using the HSM-USER iKey and the
correct password.
After a reboot has occurred (whether intentionally invoked by the user,
or due to a power failure for example), the affected ASA 310-FIPS
device will not process any SSL traffic until you first log in to the ASA
310-FIPS (with administrator or operator privileges), and then issue
the login command to log in to the HSM cards. You will then be
requested to insert the card-specific HSM-USER iKey, and provide the
password that is associated with the inserted HSM-USER iKey.
When you have inserted the requested HSM-USER iKeys and provided
the associated passwords, alarms that were set during the reboot
are cleared. The ASA 310-FIPS device can then start processing
SSL traffic again. For detailed information on how to perform this
operation, see the section "An ASA HSM Stops Processing Traffic" in
the "Troubleshooting the NVG " chapter in the User's Guide.
Nortel VPN Gateway
Command Reference
NN46120-103 01.01 Standard
10 September 2007
/maint/hsm Hardware Security Module Menu 475