Nortel 3050 Command Reference Manual page 186

186 Command Reference
Table 55
Idle Timeout Menu Options (/cfg/vpn/aaa/auth/radius/idletimeou)
Command Syntax and Usage
vendorid <integer value>
vendortype <integer value>
ena
Copyright © 2007 Nortel Networks
.
Assigns the SMI Network Management Private Enterprise Code—as
defined by IANA in the file http://www.iana.org/—to the Vendor-Id
attribute.
The Vendor-Id—represented by the private enterprise number—is a
value for RADIUS' standard attribute vendor-specific (26).
Contact your RADIUS system administrator for information about which
value to use.
If you want to use a standard attribute type as defined in RFC 2865,
set vendorid to 0. Then configure the desired standard attribute type
as the vendor type value (see next command).
Note: If both Vendor-Id and Vendor-Type is set to 0, the VPN Gateway
will pick up the Idle-Timeout standard attribute (if sent from the RADIUS
server). If vendor-specific attributes are specified on the RADIUS server
and in the CLI (using Vendor-Id and Vendor-Type), the standard attribute
will be overridden.
Assigns a number to the Vendor-Type attribute used in RADIUS.
Used in combination with the Vendor-Id number, the Vendor-Type
number identifies the idle timeout attribute configured in RADIUS.
The usage of the Vendor-Type attribute conforms to the
recommendations in RFC 2865.
Contact your RADIUS system administrator for information about which
value to use.
Note: If both Vendor-Id and Vendor-Type is set to 0, the VPN Gateway
will pick up the Idle-Timeout standard attribute (if sent from the RADIUS
server). If vendor-specific attributes are specified on the RADIUS server
and in the CLI (using Vendor-Id and Vendor-Type), the standard attribute
will be overridden.
Enables retrieval of the RADIUS server idle timeout value.
The feature is enabled by default.
Nortel VPN Gateway
Command Reference
NN46120-103 01.01 Standard
10 September 2007