Nortel 3050 Command Reference Manual page 433

Table 178
Host Port Menu Options (/cfg/sys/host/port) (cont'd.)
Command Syntax and Usage
mode full|half
/cfg/sys/routes Cluster Wide Routes Configuration
[Routes Menu]
list - List all values
del - Delete a value by number
add - Add a new value
The Routes menu is used for managing static routes on a cluster-wide
level when more than one interface is configured. To configure static
routes for a specific host, use the /cfg/sys/host #/routes command.
To configure static routes for a specific interface, use the /cfg/sys/host
#/interface #/routes command.
Table 179
Routes Menu Options (/cfg/sys/routes)
Command Syntax and Usage
list
del <static route by index number>
add <destination IP address> <subnet mask> <gateway IP address>
/cfg/sys/time Date and Time Configuration
[Date and Time Menu]
date - Set system date
time - Set system time
tzone- Set Timezone
ntp - Configure NTP servers
Copyright © 2007 Nortel Networks
.
/cfg/sys/time Date and Time Configuration 433
Sets the duplex mode for the currently selected host and NIC port when
autonegotiation is set to off.
The default duplex mode is set to full.
Lists all configured static routes by their index number and IP address
information.
Removes the specified static route from the system configuration. Use
the list command to display the index numbers of all added static
routes.
Adds a static route to the system configuration. Specify the destination
IP address, the subnet mask, and the gateway IP address.
Nortel VPN Gateway
Command Reference
NN46120-103 01.01 Standard
10 September 2007