Removing The Developing Assembly; Points To Note When The Developing Assembly; Removing The Hopper - Canon iR7086 Series Service Manual

Chapter 7
1) Open the manual feeder tray cover.
2) Remove the pull-off roller unit.
3) Removing the developing assembly stay.

7.10.9.2 Removing the Developing Assembly

iR7105 / iR7095 / iR7086
1) Disconnect the two connectors [1], and slide out the developing assembly
[2] to the front.
[1]

7.10.9.3 Points to Note When the Developing Assembly

iR7105 / iR7095 / iR7086
When mounting the developing assembly, take care not to hit against the de-
veloping cylinder [1].
Check to be sure that the connector [1] will not become disconnected. Poor
contact will lead to blank prints.
Check to be sure that the developing assembly locking plate is free of a gap
and displacement, which are likely to cause image faults. (Especially, it must
not be riding over the bosses found below.)
When mounting the developing assembly locking plate, take care not to trap
the cable [1].
7-38
[2] [1]
F-7-82
[1]
F-7-83
[1]
F-7-84
0010-8836
ÉRÉlÉNÉ^ÉJÉoÅ[ÇšéÊïtÇØÇÈç¤ÅAñ'ä|ÇØïî[1]ÇšÉJÉoÅ[ÇÃäOë§Ç...è
oDzDZÇýÅB(ë©ê¸ÉoÉìÉh[2]ÇÕïKdzÉJÉoÅ[ÇÃì‡ë§Ç...DzÇÈDZÇýÅB)
[1]
0011-8148

7.10.9.4 Removing the Hopper

iR7105 / iR7095 / iR7086
1) Remove the developing assembly.
2) Remove the four mounting screws [1], and disconnect the connector [2];
then, detach the hopper [3].
[1]
F-7-85
[2]
F-7-86
[3]
[1]
[2]
F-7-87
[1]
0010-8842