Canon imageRUNNER ADVANCE C5255 Series Service Manual page 265

2
Technology > Updater > Preparation > Network Settings
■ Network Settings
● Connecting to External Network
The method of connecting to external network is similar to a normal network connection
method. Refer to user manual of the device for details.
NOTE:
• Before using UGW link or User mode, see the sections below to prepare as required.
"Enabling UGW Link"
"Enabling [Update Firmware] Button of User Mode"
"Enabling [Install Application/Options] Button of User Mode"
• "External Network" here means the network connecting the device to CDS via Internet.
● Connection to the local CDS
When updating firmware using iW EMC + Device Firmware Update Plug-in (DFU Plug-in),
start service mode and enable the following setting.
[COPIER] > [OPTION] > [FNC-SW] > [CDS-FIRM]
[COPIER ] > [ OPTION ] > [ FNC-SW ] > [ LCDSFLG]
Then, disable the following setting.
[COPIER] > [OPTION] > [FNC-SW] > [CDS-UGW]
2 Technology > Updater > Preparation > Network Settings
[COPIER ] > [ OPTION ] > [ FNC-SW ]
CDS-FIRM To set whether to permit update of the firmware by user
(administrator).
When "1: Enabled" is set, Updater can be activated from the user
mode.
0 to 1
0: Disabled, 1: Enabled
LCDSFLG Whether to display or hide the screen for setting the server to be
connected
0: Hide
1: Display
CDS-UGW To set whether to permit update of the firmware from the UGW server.
When "1: Enabled" is set, Updater accepts the operation from the
UGW server in cooperation with CDS.
0 to 1
0: Disabled
1: Enabled
● Confirming URL Setting of Distribution Server
This section describes how to confirm the URL setting of the distribution server.
1. Start [Service Mode] at Level 1.
2. Press [Updater] button.
F-2-407
2-227
CDS Local
CDS
1 1
0 1
1 0
T-2-110
F-2-408
2-227